What material considerations should be made?
hydraulic institute
Acceleration transducers (accelerometers) are typically used to measure vibration on stationary components.
Accumulations of solids must be cleaned for safety reasons, among others
Shaft sleeves and bearings are among replacement parts needed
Correction factors determine head and efficiency curves for the pump when handling viscous liquids.
Correction factors determine head and efficiency curves for the pump when handling viscous liquids.
Understand energy usage and regulations to get the most out of optimization
Shaft sleeves and bearings are among replacement parts needed
Accumulations of solids must be cleaned for safety reasons, among others
The proper grease should be chosen based on factors such as moisture, bearing load, speed, temperature and shaft orientation.
The conductivity probe and float switch are the top sensors used.
Parsippany, N.J. – The Hydraulic Institute (HI) has published new American National Standards combining 1-series and 2-series standards into a single 14-series standards. Historically, HyI standards have been divided into “1-series” standards covering centrifugal pumps and “2-series” standards covering vertical pumps. These included the following standards:
Centrifugal Pump Standards
Hydraulic Institute answers question on best method to see if your bearing is failing
Hydraulic Institute answers questions on rolling element bearings and grease as a lubricant.
PARSIPPANY, N.J. – The Hydraulic Institute introduces member company, PSG a Dover Company, as the latest company to have their pump test laboratory approved through the HI Pump Test Lab Approval Program. The approved pump test lab is located at 22069 Van Buren Street, Grand Terrace, CA.
PARSIPPANY, N.J., – The Hydraulic Institute (HI) installed a new leadership team during the 2019 HI Annual Conference at the Vinoy Resort & Golf Club in St. Petersburg, Florida.
Keep personnel safe by complying with safety standards